|
|
 |
 |
 |
 |
 |
 |
| Workshop Garage Storage |
| Shirl's latest project shows a great way to tidy up your garage. |
 |
|
|
 |
1 Cut the 290 x 20mm pine to fit your garage storage unit. You can create your own configuration, with as many shelves and compartments as you like. 2 Screw and glue unit together. 3 Cut 40 x 19mm battens to fit between the side panels and vertical dividers and then screw them into place. 4 Fix ledgers on wall into studs. 5 Sit unit in place and screw through the battens to fix unit to wall.

|
Materials 290mm x 20mm pine (the number of sheets you need will depend on your individual space) 40mm x 19mm (length will depend on your individual space) Saw Hammer Drill Screw gun & Screws Glue
|
Total Cost This project cost $108, but may vary depending on the size of your unit.
|
More Info Materials available at leading hardware stores.
|
Disclaimer
All Fact Sheets and other material on the Our House website are provided as a general information service only and should not be relied upon as a substitute for the advice of a properly qualified tradesman. Neither ninemsn nor its licensors (including the Nine Network) assume or accept any responsibility for, and will not be liable for the accuracy or appropriate application of any information whatsoever in any Fact Sheet or other material on the Our House web site. Your use of the Our House web site is governed by this disclaimer and the ninemsn's Terms of Use.
|
|
 |
|
|